Mittwoch, 20. Juni 2012

Paper Feed Rollers.

4 Kommentare:

Bill M hat gesagt…

If you can't find any, heat shrink. I have an old Underwood parts machine. Either email the dimensions or good photos of them and I will see what I have.

I will not have time to take my 4B apart until about September. From this week on I will be super busy and/or travelling.

Miguel Chávez hat gesagt…

This might sound crazy, but maybe you could find a carpentry shop and ask them to turn a duplicate roller with their lathe. Could be made of soft wood, say pine, and the axis could be made with a piece of wire like the one used on large furniture hinges. In theory, if properly made, it should work decently.

Rob Bowker hat gesagt…

You could check again here for a solution to worn feed rollers.

maschinengeschrieben hat gesagt…

I know you found a ingenious solution - but before I try something irreversible, I thought, I'd try to find a matching replacement - easier said than done.

Kommentar veröffentlichen

Danke für Ihren Kommentar! Haben Sie Lust, mehr zu schreiben als einen Kommentar? Share fascination.
Thanks for your comment! Would you like to write more than a comment? Share fascination.
Es kann bis zu 24 Stunden dauern, bis ein Kommentar moderiert ist und erscheint.
It may take up to 24 hours until a comment is moderated and published.